Machined endcap with single O-ring design using Silicone 1/8 inch O-Ring AS568A Dash Number 238 http://www.mcmaster#9396K227
Pressure tested to 120 PSI (270feet aproxmility) Cad file and PDF attached note work in progress.
I was thinking about 3/16 O-ring same material.
Next is to test on tubing on high side of tolerance +.030" dia.
Thanks for sample.
Thanks for postin this Mark! You were planning on using a thicker o-ring, correct? What size were you going for next?
Sign Upor Sign In
Or sign in with:
© 2014 Created by Eric Stackpole.
Report an Issue |
Terms of Service
Please check your browser settings or contact your system administrator.