Water/ Pressure Proofing (38)

Discussions Replies Latest Activity

O-ring loose

Finally I am completing to build my rov. I mounted two o-ring on cups of cilinder, but when I insert cup it slips into with no force, o-rin…

Started by Saverio Tozzi

2 Jul 22
Reply by Saverio Tozzi

[solved] Leaking Electronics Tube

Hello Everyone! I wanted to share some photos and gather other people's valuable input into a problem that I am having trying to seal the…

Started by Michael Sinclair

6 Jun 17
Reply by Michael Sinclair

Electronics tube Condensation example

Hi, After leaving the ROV sealed up and running at my desktop for a couple of hours I was amazed about how much condensation had forme…

Started by Marcus

2 May 30
Reply by Håvard

Initial test of replacement battery tube end caps with large o-ring

I replaced the end-caps for the battery tubes for a 2.5 OROV with some newly fabricated ones that use a single larger o-ring.  Even with th…

Started by Brian A

0 May 6

Sphere as the main electronic housing

Hi Guys, I'd like to build my ROV with a sphere as the housing for the electronics to try and achieve far greater depths, I'm thinking abou…

Started by Paul

0 May 6

How deep can I take the V2.6?

Hi everyone. I can not see any real multiple tests which can tell how deep this ROV actually can go as standard built.I should maybe be an…

Started by Tom-Vidar Salangli

3 May 1
Reply by Tom-Vidar Salangli

Hermeticity prove of the electronics tube

I finished building my rov and testing the electronics, now I want to do an hermeticity testing to prove the sealing of the electronics tub…

Started by Jorge Said

1 Apr 29
Reply by Eric Stackpole

Water/pressure proofing a pressure sensor

Hi All, I'm using a Rapsberry Pi with BMP085 pressure sensor to measure depth, however the sensor isn't waterproof. I have considered a two…

Started by smooth_jamie

4 Apr 18
Reply by Edward Mallon

Potted Pass-Through

There are many instances when you may want to pass electrical wires (such as a tether, motor wires, communication lines between compartment…

Started by Eric Stackpole

26 Apr 16
Reply by Marius Antares

3d printed electronics tube caps with PLA

After looking at the E tube I thought I would give redesigning it a try. this is what I have come up with so far. I originally bought thes…

Started by jonathan pugh

3 Apr 16
Reply by Ion

RSS

© 2014   Created by Eric Stackpole.

Badges  |  Report an Issue  |  Terms of Service